Search:

2005-2010 Ford Mustang Adjustable Upper Control Arm- Roto-Joint


Application:
2005 - 2010 Ford Mustang
Does NOT fit 2011 & up


This rear upper control arm replaces the factory stamped control arm reducing wheel hop and increasing traction. The S197 Mustang chassis uses a 3-link rear suspension system with a panhard bar to control the rear end under the vehicle. Under hard loads the factory pieces tend to flex and rubber bushings deflect leading to poor traction and erratic handling. Replacing the factory pieces with stronger well designed items eliminates this flex allowing for better control of the vehicle and improved traction during launches.

This upper control arm is a direct bolt-on replacement and features a spherical Roto-Joint. The Roto-Joint design is a pivot ball lined with a greaseable delrin race designed to offer 28 degrees of total unrestricted movement, more than adequate for a bind free, low friction operation. The Roto-Joint design improves performance over the factory rubber and aftermarket polyurethane bushings by allowing the suspension to articulate correctly, and provides precision handling. The installed UMI Roto-Joint allows rear end free movement when high handling, auto cross or road race is a concern while still being a 100% streetable setup. The installed delrin race, which lines the spherical ball, absorbs shock and road noise for a quiet and smooth operation on any street or track driven vehicle.

Features:

  • On car adjustable using a chrome moly, heat treated adjuster
  • Mounting plate CNC machined from 0.250” thick mild steel
  • Fully TIG welded for superior strength
  • 4140 chrome moly threaded tube adaptors
  • Spherical Roto-Joints installed
  • Shipped fully assembled and ready to install
  • Uses OEM hardware
  • Brilliant and durable powder coat finish


Spacer Kit: Part #1058 spacer kit designed to fix the oversized hole problem with the factory rear upper control arm mount. Where the rear upper control arm mounts to the chassis Ford uses a 14mm bolt and a 14mm hole in the upper control arm, however the hole in the chassis mount is 16mm. This stepped spacer set is designed to take up this slop and eliminate noise and clunks from the upper control arm area. This is done by reducing the hole size from 16mm to 14mm which does not allow the bolt to shift during acceleration and braking. The spacer kit slides into the upper mount and steps the hole size down to the correct diameter of 14mm, this allows for a tighter fit and no more clunking! Note: This kit is designed to work with the OEM upper control arm mount. It will work only on aftermarket control arm mounts that use a 16mm hole. Most aftermarket companies supply there new upper mounts with 14mm holes.

Product Options:










Add to Cart:

Starting at: $149.99

  • Part #: 1062
  • Manufactured by: UMI Performance Inc.
Ask a question

Additional Product Images




Copyright © 2019 UMI Performance Inc.. Powered by Zen Cart